PLACEHOLDER Stucco Co.logo.svg — 320×80

Service · PLACEHOLDER City, ST

Stucco Re-Coat and Refinishing in PLACEHOLDER City, ST

A fresh finish coat over sound existing stucco. New color, new texture, patches disappear, no demolition.

20+ years in business

Plastering since 2005, same crew leads on every job.

Locally owned

One shop, one service area, no franchise call center.

Highest-rated crew in the area

Referral work and repeat GC clients make up most of our schedule.

If the wall behind your finish is still solid, you do not need new stucco. You need a new face on the stucco you already have. A re-coat bonds a fresh finish layer over the existing wall, which erases old patches and color mismatch and gives you a uniform elevation again.

It is the highest-value job we do in PLACEHOLDER City. Homes that look tired from the curb come back looking new for well under the cost of a tear-off and replacement.

gallery-03.jpg 900 × 900 Re-coat over an older home exterior

When a re-coat is the right call

Good candidates have sound, well-bonded stucco with cosmetic problems: faded or chalky color, a patchwork of previous repairs, dated texture, or hairline cracking spread across the panels. Bad candidates have debonded areas, active water intrusion, or a failed weather barrier — those get repaired first, or the new finish just hides a problem that is still growing.

What the re-coat process looks like

We pressure wash and let the wall dry, repair cracks and damage so the substrate is uniform, mask everything that is not getting coated, apply a bonding agent where the surface calls for it, then apply the new finish coat and texture across the full elevation, corner to corner, so there is no lap line in the middle of a wall.

Color is integral in the finish where possible, which means it goes all the way through the coat instead of sitting on top like paint. Chips and scuffs later do not expose a different color underneath, and there is nothing to peel.

Re-coat, fog coat, or paint

A fog coat is a thin cement and pigment slurry that renews color without changing texture — the cheapest way to even out an aging wall. A re-coat is a full finish layer that changes both color and texture. Paint is the least breathable of the three and starts a maintenance cycle you have to repeat. We generally steer homeowners in the PLACEHOLDER Valley toward the cement-based options for that reason.

Stucco Re-Coat & Refinishing across PLACEHOLDER County

We run this work throughout PLACEHOLDER City and the surrounding towns. In places like PLACEHOLDER City Two, PLACEHOLDER City Three and PLACEHOLDER City Four, no two elevations are exactly the same, so every job gets scoped on site rather than over the phone.

Common questions

Stucco Re-Coat & Refinishing questions we hear in PLACEHOLDER City

A re-coat is typically a fraction of a full tear-off and replacement because there is no demolition, no new lath and no new drainage plane. Pricing depends on square footage, access and how much repair the wall needs first.

What neighbors say

Referral work is most of our schedule

PLACEHOLDER review. Two to four sentences in a real customer voice, naming the job and the city.

PLACEHOLDER Name — PLACEHOLDER City

PLACEHOLDER review. Mention a specific detail — the crack repair matched, the crew cleaned up, the estimate held.

PLACEHOLDER Name — PLACEHOLDER City

PLACEHOLDER review. Something about responsiveness or the written scope works well here.

PLACEHOLDER Name — PLACEHOLDER City

Get a straight answer on your wall

Free on-site estimates across PLACEHOLDER City and PLACEHOLDER County. We look at the actual wall, measure the elevations and send a written scope — no charge and no sales pitch.

Call now Free estimate